C7 ACERT™ (Hazardous Location) Standard Equipment

• Air Inlet System
  • Turbocharger, separate circuit (SCAC) or remote (REMAC) aftercooler
  • Single, right-side, center-mounted turbo with water-cooled turbine housing
  • Air inlet, RH side, rear facing, 101.6 mm (4 in.) connection type

• Control System
  • Electronic governing, PTO speed control
  • Programmable ratings
  • Cold mode start strategy
  • Automatic altitude compensation
  • Fuel cooled ECU
  • Power compensation for fuel temperature
  • Programmable low and high idle
  • Electronic diagnostics and fault logging
  • Programmable monitoring system (engine speed, temperature, pressure)
  • J1939 broadcast (diagnostic and engine status)
  • Certified electrical control system
  • Derated engine: automatic ambient temperature compensation

• Cooling System
  • Thermostats and housing, front-facing outlet — 51 mm (2.01 in) connection
  • Jacket water pump — belt-driven, centrifugal
  • Water pump — inlet RH front vertical inlet (pointing down) — 63 mm (2.48 in)

• Exhaust System
  • Single, right-side, center-mounted turbo with water-cooled turbine housing
  • Exhaust manifold — water-cooled
  • Front turbo exhaust

• Flywheels and Flywheel Housing
  • Mandatory selection of: SAE No. 1, SAE No. 2, or SAE No. 3 flywheel and housing SAE standard rotation

• Fuel System
  • HEUI fuel system
  • Fuel filter — secondary, LH front (2-micron high performance)
  • Fuel transfer pump — left front
  • Fuel priming pump — left front

• Lube System
  • Crankcase breather — top rear
  • Crankcase fumes disposal — RH
  • Oil cooler — RH
  • Oil filter — RH
  • Oil pan — front sump, 31 L (33 qt) oil change capacity
  • Oil filler — front top valve cover
  • Oil level gauge — LH rear
  • Engine oil pump — gear-driven
  • Oil valve sampling, RH

• Power Take-Offs
  • Crankshaft drive pulley — 2 grooves, 190 mm (7.5 in) diameter, 22.3 mm (0.88 in) wide

• General
  • Vibration damper
  • Lifting eyes
  • Literature
  • No paint

• Mandatory Options
  • Flywheel housing and flywheel
  • Primary filter/water separator
  • Turbo orientation

C7 ACERT™ (Hazardous Location) Optional Equipment

• Air Compressors
  • Air compressor governor

• Air Inlet System
  • Precleaner
  • Air inlet elbow
  • Charging System
  • Cooling System

• Emissions Certifications
  • IMO certification

• Flywheels and Flywheel Housing
  • Crankshaft seal

• Instrumentation
  • Gauges and instrument panels

• Lube System
  • Oil pans
  • Drain and cover
  • Remote oil filters
  • Lubricating oils

• Mounting System
  • Structural steel base
  • Engine support — front and rear

• Power Take-Offs
  • Rear enclosed clutches
  • Hydraulic pump drives
  • Crankshaft pulleys

• General
  • Tool set