C175-20 (50 Hz) Standard Equipment

• Air Inlet
  • 4 x Single element canister air cleaners with service indicator(s).

• Control Panel
  • EMCP 4.2
  • Emergency stop pushbutton
  • 24 Volt DC operation
  • Environmental sealed front face
  • Text alarm / event descriptions
  • Wall Mounted Controls
  • Speed adjust
  • Auto / start / stop control
  • Engine cool-down timer
  • Engine cycle crank
  • Alarm acknowledge
  • Lamp test
  • True RMS AC metering, 3-phase, +/-2% accuracy
  • Digital Indicators
  • RPM
  • DC volts
  • Operating hours
  • Oil pressure (psi, kPa or bar)
  • Coolant temperature
  • Volts (L-L & L-N)
  • Frequency (Hz)
  • Amps (per phase & average)
  • Warning / shutdown Indicators
  • Low oil pressure
  • High coolant temperature
  • Overspeed
  • Emergency stop
  • Failure to start (overcrank)
  • Low coolant level
  • 4 Programmable relay Inputs
  • 4 Programmable relay output

• Cooling System
  • SCAC cooling
  • JW Inlet: 6" ANSI / JW Outlet: 5" Cat Flange
  • AC Inlet: 6" ANSI / AC Outlet: 3-1/2" ANSI
  • Coolant Sensors

• Exhaust
  • Dry exhaust manifold
  • Bolted flange (ANSI 6" & DIN 150) with bellow for each turbo (Qty 4). 50 Hz

• Fuel
  • Primary fuel filter water / fuel water separator
  • 10 Micron Spin On Type
  • Filters x 3
  • Secondary / tertiary fuel filters
  • 4 Micron spin on type
  • Engine mounted filters x 3

• Generators and Attachments
  • 3 Phase brushless
  • Salient Pole
  • 6 Leads
  • IEC Platinum Stator RTDs
  • Voltage Regulator:
  • Reactive droop capability
  • 3 Phase voltage sensing
  • RFI suppression
  • Min/max Exciter limiter
  • Exciter diode monitor
  • Form Wound
  • Permanent Magnet
  • NEMA Class H insulation
  • Class H temperature rise at 40C ambient
  • Anti condensation space Heater
  • Right side extension box, bottom cable entry

• Governing System
  • ADEM A4
  • Redundant Shutdown (Overspeed protection through a duplicate speed sensing system)

• Lube System
  • Lubricating oil
  • Gear type lube oil pump
  • Integral lube oil cooler
  • Oil filter, filler and dipstick
  • Oil drain lines and valve
  • Fumes disposal

• Mounting Systems
  • Rails - Engine/Generator
  • Rubber anti-vibration mounts (shipped loose)

• Starting / Charging System
  • Dual 24 volt electric starting motors
  • Batteries and battery rack w/cables
  • Battery disconnect switch

• General
  • Paint - Caterpillar Yellow with high gloss black rails
  • Right hand service
  • SAE standard rotation

C175-20 (50 Hz) Optional Equipment

• Air Inlet Systems
  • Single element air cleaner

• Control Panels
  • EMCP 4.3
  • EMCP and MV and HV power connection locations
  • Load share module
  • EMCP voltage and current sensing groups
  • Speed adjust
  • Annunciator modules
  • Customer interface options
  • Generator temperature monitoring
  • E-Stop
  • Interconnect harness
  • Generator harness
  • Modbus monitoring of packages
  • Vandal proof panel door

• Cooling System
  • Package mounted radiators
  • Remote radiators
  • Fuel cooler

• Crankcase Systems
  • Explosive relief valves
  • Crankcase ventilation system

• Exhaust System
  • Front housing - Standby or mission critical
  • Front housing - Prime or continuous
  • Exhaust collectors / Manifold
  • Mufflers (15, 25 and 34 dBA)

• Fuel System
  • Primary fuel filter

• Generators and Attachments
  • Medium voltage - 3000 Frames - 50 Hz, 3 phase, 1500 rpm, FW, PM, No of leads=6, Pitch 0.6667
  • Thermostat for space heater
  • Generator air cleaner
  • Differential current transformers - (5, 9 and 15 kV Class)

• Instrumentation
  • Pyrometer and thermocouples

• Lube System
  • Lube oil heater
  • Lube oil heater with crankcase explosion relief valve
  • Drain group oil pans
  • Lubricating oil
  • Electric prelube pumps
  • Oil filters

• Mounting System
  • Rubber anti-vibration mounts
  • Spring type linear vibration isolators
  • IBC vibration isolators - Shipped loose

• Special Tests / Reports
  • Generator test report
  • PGS test report @ 1.0 power factor
  • PGS test report @ 0.8 power factor
  • Standard genset TVA (Torsional Vibration Analysis) report
  • Custom genset TVA report
  • Special test charge - Engine only
  • Genset fuel consumption test
  • Standard engine test charge

• Starting / Charging System
  • 24 Volt electric starting motors
  • Air starting motor
  • Air pressure regulator
  • Starter location covers
  • 24 Volt battery sets - Dry
  • 20, 35 and 50 Amp battery chargers
  • Charging alternators - Dry
  • Jacket water heaters

• General
  • Special paint - 3500, Colors (other than Caterpillar yellow) or high performance paints
  • US aid emblem
  • Service tools
  • Engine barring group
  • Manual
  • Engine barring Air powered
  • control GP - Air powered bar group